多行文本内容元素

富文本内容绑定数据后可解析HTML语言内容

The fixed installation of the machine must be kept at the front, back, left and right levels (judging according to the fluidity of peanut kernels), otherwise there will be a mixed phenomenon of outlet kernels. The method of leveling is: the side with more peanuts indicates that this side is lower, and the wheels on this side should be slightly lifted with a sack (the new environmental machine should be adjusted in the opposite direction); If the outlet of a small fruit is mixed with nuts, it means that the edge is too low. If it is low, the guide wheel should be raised.

First, the preparation before the use of grain and oil shelling machine:

1. Connect the 380 volt three-phase power supply before use, and then start the motor through the hydraulic press, and the direction of steering is the same as the indicated arrow.

2. After trial operation, if all parts of the machine operate normally and there is no abnormal impact, it can be put into production.

3. Before starting production, please make sure to use the appropriate specification screen to improve production efficiency and reduce the crushing rate.

4. Don't dry the peanuts too much, otherwise they will break easily. The water content should be kept at about 9%. Otherwise, the damage rate will increase. In this case, it is better to use the tide first and wait 4 hours before starting production in winter (2 hours in spring).

Grain and oil shelling machine

Second, the operation method of grain and oil shelling machine:

1. The fixed installation of the machine must be kept at the front, back, left and right levels (judging according to the fluidity of peanut kernels), otherwise there will be a mixed phenomenon of outlet kernels. The method of leveling is: the side with more peanuts indicates that this side is lower, and the wheels on this side should be slightly lifted with a sack (the new environmental machine should be adjusted in the opposite direction); If the outlet of a small fruit is mixed with nuts, it means that the edge is too low. If it is low, the guide wheel should be raised.

2. During the operation of the cottonseed shelling machine, the feed should be kept uniform, first start the host motor idling, and then start the stone remover feed.

3. When the peanut kernels on the sieve surface are about 30mm thick, open the kernel plate so that the peanut kernels and small fruits flow out in different directions. After that, adjust the opening of the kernel plate so that the peanut kernel lags behind the kernel plate as much as possible, and the peanut kernel and skin will not produce a certain extent, otherwise it will affect the quality of hulling.

Cottonseed shelling machine

4. If many peanut kernels gather at the service port during use, the stopper plate is fully open and still cannot flow out smoothly. At this time, the guide wheel can be slightly lifted and the peanut kernels can flow out smoothly.

5. If you find that the damage rate is high during use, it should be solved from two aspects. One is to adjust the gap between the teeth of the flat sieve and the lower sieve. As a rule, the first studio is 40mm, the second is 22-25mm (the new machine has been adjusted at the factory); The second is to replace the large gap at the bottom.

6. Before starting the machine, a starting signal should be issued. After the machine is idling for 1-2 minutes, the abnormal situation can be confirmed before operation. The stone cutter should be turned off first and then turned off. After the host works for 2-3 minutes, you can confirm that there are no materials in the computer room. Power off the console.

7. If there is too much peanut skin in the returned material during use, the hydraulic press should raise the windshield of the upper hair dryer to increase the air intake. Conversely, if the peanut skin on the outside of the blower is found to be rich in peanuts, the amount of air intake should be reduced. There is also a bezel at the exit that can be adjusted up or down to get a satisfactory result.